PLANO · DALLAS · FORT WORTH · FRISCO · MCKINNEY · ALLEN
Dryer Vent Cleaning in Plano, TX
If a load takes two or three cycles to dry, the vent is restricted. We clear it, photograph what came out, and tell you how long the run is and how often it will actually need doing.
Book a free inspectionThe whole run, not just the hood
A dryer vent is not one piece. There is the flexible transition hose behind the appliance, the rigid duct running through the wall, ceiling or attic, and the exterior hood or roof flapper where it exits. Lint collects in all three, and clearing one without the others leaves the restriction in place.
We clear the run with a rotating brush that agitates packed lint off the duct wall while a vacuum draws it out — the same Rotobrush system we use on ductwork. Suction alone does not shift lint that has compacted at a bend.
Where the lint actually builds up
Most of it collects at the bends and at the exit. Long runs through an attic or out through a roof flapper trap more than a short run through an exterior wall, and a transition hose that has been crushed behind the dryer will clog again within weeks however well the rest of the line is cleared. We photograph the run so you can see which of those applies to your home.
When To Call Us
6 signs your dryer vent is blocked
Most companies will tell you to clean the vent once a year. The honest answer is that it depends on how long your run is, how it is routed, and how much laundry the house does — a short run out an exterior wall is a different problem from thirty feet through the attic to a roof flapper. What does not vary is what a blocked vent looks like from your laundry room.
Two or three cycles to dry one load
The clearest sign, and the one most people live with for months. If a normal load no longer dries in one cycle, air is not leaving the machine fast enough.
The drum or the room is hot to the touch
Heat that should be going out the vent is staying in the appliance and the laundry room. This is the sign that matters most, because heat plus lint is how dryer fires start.
The dryer shuts itself off mid-cycle
A thermal cut-off switch stopping the machine before the load is dry means it has already overheated once. Do not keep restarting it.
Lint showing at the outside hood
Go and look at the exterior hood or roof flapper while the dryer runs. If the flap is not opening, or lint is packed around it, the line is blocked at the exit.
A burning smell when it runs
Lint scorching against the heating element. Stop using the dryer and get the line cleared before you run another load.
You have never had it done
Common in homes bought second-hand — the run came with the house. If nobody can tell you when it was last cleared, it is worth an inspection, and ours costs nothing.
Recognise two or more of these? The inspection is free.
Book a free inspectionYou see what came out
Most dryer vent cleaning ends with a van pulling away and no way to know whether the line is actually clear. Every job we do ends with photographs of the run and of the lint we removed, and a note of how long your run is and how it is routed — so the next time you book, you know what you are buying.
Photographed, not described
The lint that came out of your line, and the vent before and after. Not a technician’s word for it.
Your run, written down
Length, routing, where the bends are, the condition of the transition hose and the exterior hood. It tells you how often this will realistically need doing.
No decision in the hallway
You get the report and the quote in writing, and you decide in your own time. Nothing is booked while we are standing in your home.
Common questions
Loads taking two or three cycles is the usual sign. Also: the drum or the laundry room hot to the touch, the dryer shutting off before the load is dry, lint packed around the exterior hood, or a burning smell when it runs. Any of those means the line is restricted.
It depends on the run. A short line out an exterior wall in a two-person house will go much longer than a thirty-foot attic run in a family home. Rather than sell you an annual schedule, we measure your run, write down how it is routed, and tell you what that means for your interval.
The transition hose behind the dryer, the full duct run including any attic or roof sections, and the exterior hood or roof flapper. We clear it with a rotating brush and vacuum rather than suction alone, because compacted lint does not move under suction. You also get photographs of the run and of the lint removed.
Most residential dryer vents take under an hour. Longer runs, roof terminations or heavy lint build-up can take more. The technician confirms the time once they have seen the vent run.
On a short, straight run that exits through an exterior wall at ground level, a rod-and-brush kit will do a reasonable job. It is worth knowing the two ways it goes wrong: brush heads unscrew and get left in the line, which turns a restriction into a blockage, and long or roof-routed runs cannot be reached from either end. A leaf blower moves air but does not dislodge packed lint.
Yes — it is a separate service with its own page. If you are booking both, say so when you call and we will inspect both systems in the same visit.
